GPS Garmin TT 10のPDF バッテリー交換方法をオンラインで閲覧またはダウンロードできます。Garmin TT 10 2 ページ。
Garmin TT 10 にも： オーナーズマニュアル (26 ページ), ユーザーマニュアル (5 ページ)
ページを印刷する
TT™ 10 Battery Replacement
Instructions
TT 10 Components
Back plate
Power key
Battery cover
Connectors
Battery
Removing the Old Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. Also, you need a small Phillips
screwdriver.
1
Remove the six screws from the outer edges of the back
plate.
July 2012
TIP: You should leave the two inner screws in place.
2
Pry off the back plate.
3
Disconnect the four-pin and five-pin connectors.
4
Remove the three screws that secure the battery cover.
5
Remove the battery cover and the battery.
Remember the orientation of the battery. You must install the
new battery the same way.
After you remove the old battery, contact your local waste
disposal department to properly recycle the battery.
Installing the New Battery
Before you replace the battery, you must remove the old battery
(page
1). You also need a small Phillips screwdriver. You may
need a small flat screwdriver to connect the connectors.
1
Install the new battery with the connector on the end nearest
the Power key.
2
Replace the battery cover.
3
Replace the three screws to secure the battery cover.
4
Connect the five-pin and four-pin connectors.
You may need to use a flat screwdriver to help secure the
connectors.
5
Select the Power key to test the connections.
When properly connected, a tone is emitted and the status
LED blinks green.
TIP: You can turn off the device before proceeding.
6
Make sure the gasket located inside the bottom cover is fully
seated.
7
Replace the back plate.
8
Replace the six screws to secure the back plate.
After you install the new battery, charge the collar completely.
Limited Warranty
The Garmin
standard limited warranty applies to this
®
accessory. For more information, go to
/support/warranty.html.
190-01500-02_0A
www.garmin.com
Printed in Taiwan