- ページ 6
カーナビゲーションシステム Garmin zumo 395LMのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Garmin zumo 395LM 27 ページ。
ページを印刷する
Attaching the Base Plate to the Motorcycle Mount
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
washers
, cradle, spacers
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
base plate
with each end of the double-socket arm
2
Insert each ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Installing Your Device in the Motorcycle Mount
1
Fit the bottom of your device into the cradle.
2
Tilt the device back until it snaps into place.
3
If the latch on top of the mount stays up after you insert the
device, press it down.
2
NOTICE
through the
, and base plate
.
and the ball of the
Removing Your Device from the Motorcycle
Mount
1
Press the release button on the side of the mount.
2
Lift out the device.
Mounting Your Device in an Automobile
Before mounting the device, check the local laws pertaining to
windshield mounting.
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
1
Plug the automotive power cable
mount.
.
2
Remove the clear plastic from the suction cup
3
Clean and dry your windshield and the suction cup with a lint-
free cloth.
4
Press the suction cup to the windshield, and flip the lever
back toward the windshield.
5
Snap the cradle
6
Fit the bottom of your device into the cradle.
7
Tilt the device back until it snaps into place.
8
Plug the other end of the automotive power cable into a
power outlet.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
• Update the maps and software on your device
Updates, page
• Mount the device and connect it to power
page
1).
• Pair your Bluetooth
and Headset, page
• Acquire GPS signals
• Adjust the screen brightness
Brightness, page
• Navigate to your destination
NOTICE
WARNING
into the port
onto the suction cup arm.
Getting Started
WARNING
3).
(Installation,
phone and headset
(Pairing Your Phone
®
12) (optional).
(Acquiring GPS Signals, page
(Adjusting the Screen
4).
(Starting a Route, page
on the
.
(Support and
3).
5).
Getting Started