- ページ 10

アビオニクス・ディスプレイ Garmin G3000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Garmin G3000 18 ページ。 Swapping gsa80 roll & gsa80 yaw servo on citation cj3+

Determine Options Installed (Options That Can Only Be Seen In Configuration Mode)

Note: This is with the G3000 still powered up in configuration mode.

• ACARS Service Provider (Only if ACARS was determined to be an option per page 3)

o Rotate small FMS knob until on AIRCRAFT CONFIGURATION page.

o On the IATA Airline Designator line, look for a 2 letter code and check appropriate

box in the table below.

 XA designates ARINC Direct

 GS designates Honeywell GDC

 UV designates Universal Weather

ARINC Direct

• TAWS A Voice Callouts (100-400 FT) (In Addition to Standard 500 FT Callout) (Only if

TAWS A option is installed)

o The system should still be in configuration mode from before.

o Rotate the large FMS knob until on the GDU tab (near the left side of the choices).

o Rotate the small FMS knob to the right until on TAWS Configuration.

o Select VCO (voice call out) at the bottom of the display.

o VCO 500 (500 FT) is highlighted, and will always show TRUE below it, as this is

standard. Do not mark YES for this part.

o Rotate the small FMS knob to the right one turn to change to VCO 400 (400 FT).

o If it is FALSE below the VCO 400 under the Enabled line, then the TAWS A

Callout feature is not turned on (Second Image). Select NO.

o If it is TRUE below the VCO 400 under the Enabled line, then the TAWS A Callout

feature is turned on (Third Image). Select YES.

YES

Version 1.0

REFERENCE ONLY

Honeywell GDC

REFERENCE ONLY

Universal Weather

Standard 500 FT VCO