- ページ 6

アビオニクス・ディスプレイ Garmin GTX GTX 330DのPDF パイロット・マニュアルをオンラインで閲覧またはダウンロードできます。Garmin GTX GTX 330D 13 ページ。 Mode s transponder
Garmin GTX GTX 330D にも：パイロット・マニュアル補遺 (50 ページ), パイロット・マニュアル補遺 (50 ページ), パイロット・マニュアル (13 ページ), インストレーション・マニュアル (49 ページ)

Function Display

NOTE: GTX 330 options are normally set at time of installation. For changes

to the GTX 330 parameters, contact your Garmin authorized dealer.

When the PRESSURE ALT page is displayed, an arrow may be displayed to the right of

the altitude, indicating that the altitude is increasing or decreasing. One of two sizes of arrows

may be displayed depending on the vertical speed rate. The sensitivity of these arrows is

initially set during transponder installation.

PRESSURE ALT: Displays the altitude data supplied to the GTX 330 in feet,

hundreds of feet (i.e., flight level), or meters (dependent upon installation

configuration).

FLIGHT TIME: Timer start is configured as either Manual or Automatic.

When Manual, displays the Flight Time, controlled by the START/STOP

and CLR keys. When Automatic, the timer begins when take off is sensed.

ALTITUDE MONITOR: Controlled by START/STOP key. Activates a

voice alarm and warning annunciator when altitude limit is exceeded.

OAT/DALT: Displayed when the GTX 330 is configured with temperature

input. Displays Outside Air Temperature and Density Altitude.

COUNT UP TIMER: Controlled by START/STOP and CLR keys.

COUNT DOWN TIMER: Controlled by START/STOP, CLR, and CRSR

keys. The initial Count Down time is entered with the 0 – 9 keys.

CONTRAST: This page is only displayed if manual contrast mode is

selected during installation configuration. Contrast is controlled by the 8

and 9 keys.

DISPLAY: This page is only displayed if manual backlighting mode is selected

during installation configuration. Backlighting is controlled by the 8 and 9

keys.

ADS-B: This page is displayed if the ADS-B pilot set option is selected

during installation configuration of an ES enabled GTX 330. ADS-B defaults

to ON at each power cycle. ADS-B ON/OFF is controlled by the START/

STOP key. Turn ADS-B OFF only at the request of ATC.