- ページ 9

船舶用GPSシステム Garmin Forerunner 210のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin Forerunner 210 19 ページ。 Gps-enabled sports watch
Garmin Forerunner 210 にも：オーナーズマニュアル (28 ページ), クイック・スタート・マニュアル (13 ページ), 重要安全取扱説明書 (36 ページ), 取扱説明書 (25 ページ), 適合宣言 (6 ページ), クイック・スタート・マニュアル (13 ページ), オーナーズマニュアル (18 ページ)

Item

Description

NMEA 2000 compatible Garmin device

GPS antenna

Ignition or in-line switch

NMEA 2000 power cable

NMEA 2000 drop cable

12 Vdc power source

NMEA 2000 terminator or backbone cable

NMEA 2000 T-connector

NMEA 2000 terminator or backbone cable

NMEA 0183 Connection Considerations

• The chartplotter provides one Tx (transmit) port and one Rx (receive) port.

• Each port has 2 wires, labeled A and B according to the NMEA 0183 convention. The corresponding A and B

wires of each internal port should be connected to the A (+) and B (-) wires of the NMEA 0183 device.

• You can connect one NMEA 0183 device to the Rx port to input data to this chartplotter, and you can connect

up to three NMEA 0183 devices in parallel to the Tx port to receive data output by this chartplotter.

• See the NMEA 0183 device installation instructions to identify the transmit (Tx) and receive (Rx) wires.

• You must use 28 AWG, shielded, twisted-pair wiring for extended runs of wire. Solder all connections and seal

them with heat-shrink tubing.

• Do not connect the NMEA 0183 data wires from this device to power ground.

• The power cable from the chartplotter and the NMEA 0183 devices must be connected to a common power

ground.

• The internal NMEA 0183 ports and communication protocols are configured on the chartplotter. See the

NMEA 0183 section of the chartplotter owner's manual for more information.

• See the chartplotter owner's manual for a list of the approved NMEA 0183 sentences that the chartplotter

supports.