- ページ 6

船舶用GPSシステム Garmin GHP 10 Marine Autopilot SystemのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GHP 10 Marine Autopilot System 48 ページ。 Tachometer reference
Garmin GHP 10 Marine Autopilot System にも： クイック・スタート・マニュアル (21 ページ), 取付説明書 (26 ページ), テクニカル・リファレンス (42 ページ), 適合宣言 (1 ページ), 参考 (1 ページ)

ページを印刷する
Garmin GHP 10 Marine Autopilot System 取付説明書
Ignition or
in-line switch
Red (+)
9–1 Vdc
Black (-)
A fuse
Drain (-)
Pump
(compact .1 L pictured)
notes:
•
This diagram is for planning purposes only. Specific wiring diagrams are included in the detailed installation instructions for
each component. Hydraulic connections are not shown in this diagram.
•
If your boat uses an electrical system that provides more than 12 Vdc, or if you sporadically receive tachometer errors, install an
external tachometer filter (010-11399-00). Contact your local Garmin dealer or Garmin product support for more information.
•
Connect an optional NMEA 0183-compatible GPS device to the data cable on the GHC 10. See
•
Connect an optional NMEA 2000-compatible GPS device to the NMEA 2000 network. See
* Newer ECU units are compatible with 24 Vdc systems. See
* Newer ECU units are compatible with 24 Vdc systems. See
CCU ground
NMEA 000 network (see
NMEA 000 power cable
ECU
POWER
PUMP
CCU
1 Vdc*-0 A fuse.
See
page
for
cable size and length
requirements.
GHP 10 General Wiring outline
Black (-)
page
0)
ENCODER
CCU/ECU Interconnect cable
page 25
page 25
for more information.
for more information.
Yellow CCU signal wire
(see
page
9)
GHC 10
For tachometer wiring,
see
page 7
CCU
Orange - unconnected
Red (+) White (+)
Blue (-) Black (-)
Red (+)
Brown (+)
Black (-)
Black (-)
Yellow CCU signal wire (see
page 32
page 32
for more information.
GHP 10 Marine Autopilot System Installation Instructions
}
Boat tachometer
Alarm buzzer
Shadow Drive
page
9)
for more information.