- ページ 31

船舶用GPSシステム Garmin GPS 17HVS - Receiver ModuleのPDF 技術仕様をオンラインで閲覧またはダウンロードできます。Garmin GPS 17HVS - Receiver Module 34 ページ。 Declaration of conformity
Garmin GPS 17HVS - Receiver Module にも：取付説明書 (12 ページ), インストレーション・マニュアル (16 ページ), 技術仕様 (40 ページ), 技術仕様 (37 ページ), 適合宣言 (2 ページ)

ページを印刷する

4. Select the serial port to which the GPS 17x

HVS is connected. Select Auto to have the

program automatically determine the baud

rate, or select Manual to manually select

the baud rate of the GPS 17x HVS. Click

OK when done.

5. Click the Connect icon

Comm > Connect to connect to the GPS

17x HVS.

6. To view the current programming of the

GPS 17x HVS, select Config > Get

Configuration from GPS (or press the F8

key). The current programming of the GPS

17x HVS is displayed in the window, as

shown on the previous page.

7. Open the Sensor Configuration Window by

pressing the F6 key or selecting Config >

Sensor Configuration.

8. Place a check mark in the box next to

"Binary Output Data" to change the GPS

17x HVS to Garmin Mode. The unit will

keep this change in the programming until

you change it again in the software.

Note: Selecting Config > Switch to

Garmin Mode (or pressing the F11 key)

only changes the unit to work in Garmin

Mode until power is cycled through the

unit again. For a more permanent change,

refer to step 8 above.

9. Click OK.

10. When you are ready to upload the changes

into the GPS 17x HVS, select Config >

Send Configuration to GPS (or press the

F9 key). The new configuration is then

loaded into the GPS 17x HVS.

11. You may disconnect and close the software

when finished. The software configuration

can also be saved for future reference.

Refer to

Appendix E: Sensor Configuration Software

Configuration Software application.

190-00885-07

, or select

for complete information about downloading the Sensor

GPS 17x HVS Technical Specifications

Page 27

Rev. A