- ページ 8

船舶用GPSシステム Garmin GPS 400WのPDF 補足マニュアルをオンラインで閲覧またはダウンロードできます。Garmin GPS 400W 12 ページ。 Garmin gps receiver quick reference guide
Garmin GPS 400W にも：パイロット・マニュアル補遺 (24 ページ), パイロット・マニュアル補遺 (50 ページ), クイック・リファレンス (23 ページ), パイロット・マニュアル補遺 (24 ページ), クイック・リファレンス・マニュアル (25 ページ)

ページを印刷する

11. OBS Operation

SUSP after canceling OBS when on From side of OBS

path – The change in behavior is this: When you put the

400W/500W-series unit into OBS mode and the course

selected places the aircraft onto the from side and then

you cancel OBS, the OBS course is retained but the unit

indicates that sequencing is suspended by annunciating

SUSP. Note that you can still change the course to the

OBS waypoint as long as you haven't cancelled OBS, but

once you have it will annunciate SUSP. The WAAS TSO

requires the unit to annunciate when leg sequencing is

suspended, so this is the reason the SUSP annunciation

is active. The classic product behaved the same way but

did not indicate that sequencing was suspended and

when pressing the OBS key, it would return to OBS

mode on the same waypoint. With the 400W/500W-se-

ries unit, pressing the OBS key when the SUSP an-

nunciation is above it will allow leg sequencing to occur

immediately.

See the Q & A comments about using the OBS key in

Appendix C - Troubleshooting Q&A of the Pilot's Guide for

more details.

12. Hold to Altitude

The Hold to Altitude legs now use baro-corrected

altitude if it is available (similar to Fix to Altitude legs).

This means that if baro-corrected altitude is available

and the required altitude is reached for the hold, the

400W/500W-series unit will automatically unsuspend

and then sequence to the next leg after the hold fix is

crossed. If baro-corrected altitude is not available, then

the behavior is the same as the Classic – the user needs

to press OBS to sequence past the hold.

See the section on Flying an Approach with a Hold in the

Procedures chapter of the Pilot's Guide for more details.

13. Parallel Track

Parallel Track allows you to create a parallel course

offset of 1 to 99 NM to the left or right of your current

flight plan. After setting a parallel track to your current

flight plan, a magenta parallel track active leg line will be

drawn offset from the original by the selected distance.

The original course line will appear in white. The aircraft

will navigate to the parallel track course line.

Points to remember with Parallel Track:

1. You must have an active flight plan.

2. The current leg must support parallel track.

3. Parallel track is not allowed for the active leg of an

approach.

4. Parallel track is not allowed if the active leg is not a

track-to-fix or direct-to-fix leg.

5. Parallel track may be allowed but not the selected offset

distance.

6. Parallel Track offset waypoint is indicated with a "-p"

suffix.

Original waypoint

Original flight

plan course

line

After setting a parallel track to your current flight plan, a

magenta parallel track line will be drawn offset from the

original by the selected distance. The original course line

will be drawn in white. The aircraft will navigate to the

parallel track course line.

Navigating Along A Parallel Track

See the section on Parallel Track in the Flight Plan chap-

ter of the Pilot's Guide for more details.

Parallel Track offset waypoint

Present

Position