Making the Final Connections to the GPSMAP 4000/5000 Series Chartplotter
After the power cable and the GPS antenna (as well as any optional Garmin Marine Network devices, NMEA 0183 devices, NMEA 2000
connections, or video connections) are wired to the boat, the cables must be connected to the GPSMAP 4000/5000 series chartplotter.
There are seven connectors on the back of the chartplotter, one for power, three for Garmin Marine Network devices, one for the NMEA 0183
cable, one for a NMEA 2000 cable, and one for the marine video cable.
To attach the power cable, the NMEA 0183 cable, and the marine video cable, carefully press the cable into the correct port on the back of the
chartplotter until it is firmly seated. Do not force the cable, because this may damage the pins. After the cable is seated, turn the locking ring
clockwise until it stops.
To attach a Garmin Marine Network cable or a NMEA 2000 Micro-connector cable, carefully press the cable into the correct port on the back of
the chartplotter until it is firmly seated. Do not force the cable, because this may damage the pins. After the cable is seated, turn the locking
ring clockwise until it is tight. Be careful not to overtighten the locking ring.
NMEA 000 cable
Micro-connector
Garmin Marine Network
connectors
Your GPSMAP 4000/5000 series chartplotter may contain a software update SD card. If so, follow the instructions provided with the card.
If a software update SD card is not included, visit
version of software on your chartplotter, select or touch
0
GPSMAP 4000/5000 Series Connectors
Updating the Chartplotter Software
www.garmin.com
Configure
>
to make sure your chartplotter software is up-to-date. To determine the
System
System Information.
>
Power cable connector
Marine video cable
connector
NMEA 01 cable
connector
GPSMAP 4000/5000 Series Installation Instructions
ページを印刷する