- ページ 6

水ポンプ alkitronic VELOXのPDF 操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。alkitronic VELOX 12 ページ。 Electric hydraulic pump

ページを印刷する

Operation and Maintenance Manual

Starting Procedure

Regularly check high pressure hoses and all

couplings as well as fittings and connections

before operating the tool. Make certain hydraulic

couplings are free of dirt before operating the tool.

Particles of dirt within the hydraulic system may

result in disturbances, faulty functions, and break

down of the motor.

Make certain the hydraulic hoses are placed in a

large radius to avoid injuries. The hoses must not

be bent, twisted, or damaged.

Note!

Check the oil level in the

showcase. The red mark

indicates the minimum

which the oil level must

not fall below.

If required, the Hydraulic

Oil (Oil grades see item

1. Technical Data) can be

refilled after removing

the Vent cap (5).

Gauge (2)

Pressure adjusting valve (3)

Vent cap (5)

Fig. 1

1. Attach the hydraulic hoses to the hydraulic torque wrench

and to the VELOX Hydraulic Pump (K). See connection scheme

page10, item 11.

2. Attach remote control (F). Make sure that all couplings

are fully engaged to avoid hydraulic oil shooting out and to

ensure that the hydraulic oil can flow.

Hydraulic hoses must be equipped in pairs with

alternating couplers and nipples to regulate pre-

(pressure) and reverse running to the piston or to

the pole side of the hydraulic cylinder (see page 9,

item 7. Technical hints).

An interruption on the return line will cause

excessive overpressure on the rod end of the

hydraulic cylinder. This may result in damage to

the tool or major injuries to the operator.

Please observe local laws and regulations when

drawing up bolt connections.

When using a hydraulic torque wrench, you must

adhere to the corresponding operation manual.

Before putting the VELOX Hydraulic Pump into

operation check the working order using a pres-

sure of max. 100 bar (procedure see item 4 and 4.1).

Fig. 2