- ページ 2

船舶用GPSシステム Garmin GPSMAP 530のPDF 基本操作をオンラインで閲覧またはダウンロードできます。Garmin GPSMAP 530 4 ページ。 Flush mount template
Garmin GPSMAP 530 にも：取付説明書 (12 ページ), クイック・リファレンス・マニュアル (2 ページ), リファレンス・マニュアル (2 ページ), 取扱説明書 (28 ページ), 適合宣言 (1 ページ), テンプレート (1 ページ)

ページを印刷する

POWER ON

The COM power/volume turns the unit on and sets the desired radio volume. The

self test screen will display brieﬂ y. If the airplane has an Avionics Master switch,

turn it on.

Database Conﬁ rmation -

Database current? Press ENT.

AOPA Air Safety Foundation

recommends using a current

database.

Instrument Panel Self Test -

Compare the GPS screen with

panel instruments. Everything

OK? Press ENT.

Map Page - When the GPS

has acquired enough satellites

for navigation, the Map page

shows your present position.

USING THE VHF COM

All COM controls and indicators are located on the left. The active

frequencies are on top, standby on the bottom. Only the standby

frequency can be tuned directly. Once tuned, it is transfered to the

active position.

Position Entry Cursor - If the tuning cursor is not currently in the

COM window, press the small left knob momentarily.

Enter Frequency - The large left knob tunes MHz. Think "big number,

big knob". The small left knob tunes kHz.

Activate Frequency - The COM ﬂ ip-ﬂ op key activates the tuned

frequency. The standby frequency becomes active, and the active

frequency becomes standby.

Adjust Volume - using the power/volume knob. Press it momentarily to disable

the automatic squelch.

EMERGENCY FREQUENCY

Press and hold the COM ﬂ ip-ﬂ op key for two seconds to quickly tune

121.5.

USING VLOC

VLOC refers to tuning and navigating with VOR and localizer (LOC)

signals. All VLOC controls and indicators are located on the left. The

active frequencies are on top, standby on the bottom.

Position Entry Cursor - If the tuning cursor is not currently in the

VLOC window, press the small left knob momentarily.

Enter Frequency - The large left knob tunes MHz. Think "big number,

big knob". The small left knob tunes kHz.

Activate Frequency - The VLOC ﬂ ip-ﬂ op key activates the tuned

frequency. The standby frequency becomes active, and the active

frequency becomes standby.

Adjust Volume - using the VLOC volume knob. Press it momentarily to enable

and disable the navigation aids ident tone.

SELECT NAV SOURCE

The CDI key toggles between GPS and VLOC outputs for the CDI or HSI. The

selected navigation source is displayed just above the CDI key.

CAUTION

Selecting the wrong CDI source is a common but serious problem.