- ページ 17

食器洗い機 AEG 645のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AEG 645 24 ページ。 Dishwasher
AEG 645 にも：取扱説明書 (25 ページ), 取扱説明書 (40 ページ), 取扱説明書 (24 ページ)

ページを印刷する

Cleaning the filters

Coarse filter (fig. 15)

Remove the coarse filter and brush it clean

under running water. Check the lower half of

this filter also and remove the food residues

which may be trapped there. Note that the

upper cylindrical section of the coarse filter

can be lifted out (fig. 16).

When replacing ensure that the upper section

sits straight and tight before re-inserting the

coarse filter.

Fine filter (fig. 17)

Clean the fine filter (a) and microfilter (b) as

and when necessary. To remove the fine filter

turn it anticlockwise. Clean it thoroughly. When

replacing the fine filter make sure that the

edge of the filter forms a proper seal with the

bottom of the tub. Then turn it clockwise.

Never carry out a wash programme without

a filter.

Maintenance

Fascia panels and controls must not be

cleaned with abrasive cleaning materials or

furniture polish. Should cleaning be necessary

use lukewarm water only.

If you think your machine is not working properly

Before you call out a service engineer check the

of the engineer calling on you.

A continuous hum can be heard?

(even when the machine is switched off)

• The anti-flood system has been activated

(see page 22).

• First close the water tap, then switch off at

the power socket and remove the plug.

• To rectify the problem, call AEG Service.

The programme does not start?

• Are the fuses in working order?

• Is the door closed properly?

(There is a short pause after the machine

has filled with water!)

The machine is not taking in any water?

• Have you turned on the tap?

• Check the water inlet hose (it must not be

kinked).

The start/indicator switch stops at the begin¬

ning of the wash (lilT) or final rinse (■>£)

cycle?

• Have you opened the water tap fully?

(See page 16.)

• Is the filter in the inlet hose blocked? The

filter is located where the hose attaches to

following points carefully, it will save you the cost

the tap. Unscrew the hose and clean the

filter under running water.

• Check the water pressure. It must be at

least 1 bar(15 Ib/sq.inch)-see page 21/22.

The dishes are not clean?

• Did you select the correct programme?

The programme has to be chosen accord¬

ing to the degree of soiling.

• Did you stack the dishes according to our

recommendations? The water sprays must

have access to the dishes from all sides -

the baskets must not be overloaded.

• Were the spray arms able to rotate freely?

When the upper spray arm is stationery it

rests at an angle to allow the remaining

water to drain off at the end of a pro¬

gramme. During the programme it will auto¬

matically return to a horizontal position.

• Are the filters clean? Have you inserted the

filters properly after cleaning?

• Did you use the correct amount of deter¬

gent?

• Check that the drain hose has been

installed according to our instructions on

page 21/22.