- ページ 3

DJ機材 A-Designs Hammer 2 EQのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。A-Designs Hammer 2 EQ 8 ページ。

Introduction

Welcome to the Analog Sound of the HAMMER 2-EQ. This is an all tube product, and there are some basics you should

come to understand before using this product for the first time.

Tubes are a component that have specialized and unique features. If you are a "pre" or baby boomer, born before 1957,

you may recall using tubes in various products, such as radios, amplifiers, and televisions. So, this is just to refresh your

memory. If you are a "post" baby boomer, this could be your first experience with tubes, so please pay close attention!

(You will be tested at the end of this manual).

Tubes are most efficient and effective when "warmed up." This means, upon starting the HAMMER 2-EQ, you should

allow the tubes to become fully heated before attempting to operate. The minimum amount of warm up time is

approximately 15 to 20 minutes.

Set up your instrumentation layout before powering up the HAMMER 2-EQ. Plug in your instrument or microphone while the

unit is off. This will prevent unwanted noise such as "pops." The same applies when you shut down. Allow a minimum of

25 seconds for the power to drain from the tubes properly. Then you can unplug your instrument or microphone.

Placing the HAMMER 2-EQ in a rack, we recommend using the first tier or allow one x space in order to properly

ventilate. Avoid overheating! Too much heat will reduce the life-span of your tubes. We also recommend strongly that

you observe SPL and shock mount any tube product.

A Designs Audio has scoured the earth for the perfect combination of tubes for this unique quality sound. Go ahead, get

started. Read the following pages carefully to become acquainted with the warmth and clarity that the HAMMER-EQ can

deliver to your recordings.

Please feel free to email A Designs via the website with any creative applications for the use of the HAMMER 2-EQ. We

have included some applications in this manual. We may just include your suggestion on our website!

Congratulations on the purchase of your HAMMER 2-EQ! Most of all have fun.

Peter Montessi, President

A Designs Audio Inc.

Hammer 2-EQ

Owner's Manual

™