- ページ 11

舶用機器 Garmin GHP 10VのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GHP 10V 20 ページ。 Marine autopilot system
Garmin GHP 10V にも：取付説明書 (48 ページ), オーナーズマニュアル (28 ページ), 取付説明書 (20 ページ)

ページを印刷する

To create a basic NMEA 2000 network for the GHC 10 and the CCU:

1. Connect three T-connectors (two of the three are not included) together by their sides.

2. A NMEA 2000 power cable (not included) must be connected to a 12 Vdc power source through a switch. Connect to the ignition switch of

the boat if possible, or through an appropriate additional switch (not included).

3. Connect a NMEA 2000 power cable (not included) to one of the T-connectors.

4. Connect the included NMEA 2000 drop cable to one of the T-connectors and to the GHC 10.

5. Connect a NMEA 2000 drop cable (not included) to the remaining T-connector and to the CCU.

6. Connect the appropriate NMEA 2000 terminators (not included) to each end of the combined T-connectors.

Caution: You must connect the NMEA 2000 power cable to the boat ignition switch, or through another in-line switch. The GHC 10 will drain your

battery if it is connected directly.

Notes:

•

To add additional sensors to your NMEA 2000 network, follow the instructions included with the sensors.

•

The GHC 10 is not powered by the NMEA 2000 network. It must be separately connected to the power source.

•

The GHC 10 must also connect to the CCU with the yellow CCU signal wire in the GHC 10 power/data cable.

GHP 10V Installation Instructions

GHC 10

Ignition or

in-line switch

Ground and

Fuse

drain wires

1 Vdc battery

T-connectors

Female terminator

Creating a Basic NMEA 2000 Network for the GHC 10 and the CCU

Power cable

Drop cables

CCU

Male terminator