- ページ 11

舶用機器 Garmin Gladiator TR-1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Garmin Gladiator TR-1 36 ページ。 Garmin tr-1 marine autopilot: user guide
Garmin Gladiator TR-1 にも：インストールとユーザーマニュアル (4 ページ), オーナーズマニュアル (13 ページ)

ページを印刷する

The Man Overboard (MOB) function causes the boat to turn to port until the reciprocal

course is established, with the goal of running alongside the point where the Plus button

was pushed, The boat path will be as shown in the fi gure below. The pilot will return to

heading hold if either of the Right Arrow, Left Arrow, or Plus buttons are pressed.

Code 14: The Man overboard maneuver can be tuned to run close to the object or point

at any given speed, but may miss at another speed. You should probably adjust the maneuver at a speed that is

below planing speed. If the object or point passes on your starboard reduce code 14.

You are responsible as the captain of your boat to use the MOB feature in a manner as to not cause harm to any

Changing Heading With MOB

person or property. Be aware of any objects in the water before pressing the MOB button. The MOB feature is

not set by GPS. Due to wind, waves and current your boat may not return to the exact reciprocal course when

the MOB button is pressed.

Code and Setup Choice on the table below.)

4. Increase an adjustable parameter one step by each press of the [UP Arrow] button. When the parameter

is adjusted to its maximum value, the [Up Arrow] LED will light. The parameter is adjusted and is in use by

the autopilot immediately.

5. Decrease an adjustable parameter one step by each press of the [Down Arrow] button. When the

parameter is adjusted to its minimum value, the [Down Arrow] LED will light. The parameter is adjusted

and is in use by the autopilot immediately.

6. To save the changes into permanent memory and make the selected function into a

startup default: Press and release the [Setup] button (the [Setup] LED should be lit),

and then press and hold the [Select Load] button. While holding down the [Select Load]

button, press and release the [Deckmount] On/Off button quickly, then release the GPS

[Select Load] button.

Description

MOB Overshoot

Code 14:

The Man overboard maneuver can be tuned to run over or close to the object or point at any given

speed, but may miss at another speed. You should probably adjust the maneuver at a speed that is below

planing speed. If the object or point passes on your starboard reduce code 14.

Change Heading Using Man Overboard

Step Turns

Code

1 most overshoot command, 40 most under shoot command

To change the settings for Man

Overboard:

1. Press and release the [Setup]

Button. The [Setup] LED will

illuminate to indicate the system

is ready to take setup commands

(button pushes).

3. Select and enter code 14 by

pressing and releasing the buttons

labeled 1 & 4 (14) until the

appropriate LED's are lit. (See the

Range of Settings

Factory Setting