- ページ 14
舶用機器 Garmin GPS 19x NMEA 0183のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPS 19x NMEA 0183 19 ページ。 Gps 19x hvs
Garmin GPS 19x NMEA 0183 にも： 取付説明書 (8 ページ), 取付説明書 (48 ページ), 取付説明書 (6 ページ), 取付説明書 (6 ページ)
ページを印刷する
Limiting the Antenna Update Rate
By default, the antenna outputs position data updates 10 times per second using serial communications rate of
38400 bps. By installing the included resistor cable, the antenna can be limited to output position updates once
per second using serial communications rate of 4800 bps.
1 Mount the antenna according to these instructions
2 If necessary, cut the cable to the appropriate length for the installation.
3 Solder the included Update Rate Select cable to the orange Accessory on wire.
4 Use the heat-shrink tubing around the soldered connections.
5 If you have not connected the antenna already, connect the power and data cable
Two-Way Communication, page
Cleaning the Outer Casing
Avoid chemical cleaners and solvents that can damage plastic components.
1 Clean the outer casing of the device using a cloth dampened with a mild detergent solution.
2 Wipe the device dry.
Appendix
Software Update
You must update the Garmin chartplotter software when you install this device. For instructions on updating
the software, see your chartplotter owner's manual at support.garmin.com.
Specifications
Dimensions (diameter x height)
Weight
Cable length
Temperature range
Case material
Water rating
Compass-safe distance
Input voltage
Max. input current
Typical input current
1
The device withstands incidental exposure to water of up to 1 m for up to 30 min, and is protected against powerful jets of water. For more information, go to
www.garmin.com/waterrating.
14
(Mounting the Antenna, page
10).
NOTICE
19
3
/
× 1
32
201 g (7.1 oz.)
30 ft. (9.14 m)
From -30° to 80°C (from -22° to 176°F)
Fully gasketed, high-impact plastic alloy
IEC 60529 IPX6 and IPX7
12.7 mm (0.5 in.)
From 8 to 32 Vdc
200 mA @ 12 Vdc
150 mA @ 12 Vdc
15
/
in. (91.6 × 49.5 mm)
16
1
2).
(NMEA 0183 Wiring for