- ページ 32

食器洗い機 AEG FAVORIT 33060 IのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG FAVORIT 33060 I 40 ページ。 Aeg dishwasher user manual

Installation and Connection Instructions

Connecting the Dishwasher

The dishwasher is fitted with safety devices that prevent the wash

water returning into the drinking water system and comply with the

applicable plumbing regulations.

• The dishwasher can be connected to cold and hot water supplies up

to max. 60 °C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Lowest permitted water pressure:

1 bar (=10 N/cm

Highest permitted water pressure:

10 bar (=100 N/cm

The water inlet hose must not be kinked, crushed or entangled when it

is being connected up.

Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet

hose to a tap with an external thread (¾ inch). The inlet hose is

equipped either with a plastic or with a metal connection nut:

– Tighten plastic hose connection nuts by hand only.

– Metal hose connection nuts must be tightened using an

appropriate tool. Finally, visually check that it is water-tight (ensure

that the tap is not dripping).

• In order that access to the tap in the kitchen is not limited by the use

of the dishwasher, we recommend the installation of an additional

tap, or fitting a two way adapter to the existing tap.

• If you need a longer water inlet hose than that supplied, VDE

approved complete hose sets are to be used. These are available from

your local Service Force Centre.

=100 kPa)

=1 MPa)

Consult your installer if the water pres-

sure is less than 1 bar.

In the case of a water pressure greater

than 10 bar, a pressure reduction valve

must be used (available from your

dealer).