- ページ 29

食器洗い機 AEG FAVORIT 40620のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG FAVORIT 40620 48 ページ。 Aeg dishwasher

Changing the wash programme after the start delay has been set:

As long as the wash programme has not yet started, you are able to

change the start delay set by pressing a wash programme button.

1. Press the button for the new wash programme and hold it down.

First, the indicator for the wash programme that was already selected

will flash.

After several seconds only the indicator for the new wash programme

will be illuminated.

2. Release the programme button.

The wash programme will start automatically following a countdown

of the hours set.

Load Sensing – Sensor Logic

If a wash programme is started even though there are only a few dishes

in the upper and/or lower rack, an intelligent electronic system adjusts

the amount of water and the duration of the wash programme to the

number of dishes. By this means it is possible to wash only a few dishes

quickly and economically. At half load (6 place settings), up to 2 litres

of water and 0.2 kWh of electricity are saved.

Only switch off the dishwasher when

gramme progress display.

1. Press the ON/OFF button.

The ON/OFF button indicator extinguishes.

Hot steam may escape from the appliance when opening the door

immediately after the end of the programme. Therefore:

2. Open the door carefully.

• Hot dishes are sensitive to knocks. The dishes should therefore be

allowed to cool down before removing them from the appliance.

• Leave the dishes in the dishwasher for approx. 15 minutes after the

end of the programme so that they dry better and can cool down.

• First empty the lower rack, and then the upper rack. By using this

procedure you will avoid any water that may be remaining in the

upper rack, dripping onto the dishes in the lower rack and leaving

water marks.

Operating Instructions

is illuminated on the pro-