- ページ 16

舶用機器 Garmin Reactor 40 KickerのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin Reactor 40 Kicker 29 ページ。
Garmin Reactor 40 Kicker にも：設定マニュアル (6 ページ), 設定マニュアル (8 ページ)

ページを印刷する

Connecting the Linkage Arm to the Steering Actuator

After you connect the linkage arm to your kicker motor tiller arm using the appropriate bracket, you must

connect it to the steering actuator.

1 Screw the linkage pin

2 Referring to the diagram, install the spacer

NOTE: You can install an additional black spacer (included) on the linkage pin if needed to help level the

linkage arm.

3 Push the R-pin

through the hole on the linkage pin to secure the linkage arm.

Installing the Throttle Actuator

Follow the throttle actuator installation instructions provided with your autotpilot system to mount the

actuator and connect it to the motor throttle.

Connecting the CCU

Route the connector end of the CCU cable to the ECU and make the connection.

You should apply dielectric grease to the pin holes on the cable connector to prevent corrosion, especially if

you are using the autopilot system in saltwater.

Connecting the Drive Actuator and Throttle Actuator

You should install the drive actuator and throttle actuator on the motor before connecting them to the ECU.

1 Route the drive actuator cable to the drive actuator and to the ECU, and make sure there is enough slack in

the cable to allow for the motor to turn fully port and starboard.

This cable cannot be extended, so if it is not long enough, you must relocate the ECU, extending the ECU

power cable if necessary

2 Connect the drive actuator cable to the drive actuator and to the ECU.

You should apply dielectric grease to the pin holes on the cable connector to prevent corrosion, especially if

you are using the autopilot system in saltwater.

3 Route the throttle actuator cable from inside the motor housing to the ECU, and make sure there is enough

slack in the cable to allow for the motor to turn fully port and starboard.

4 Connect the throttle actuator cable to the ECU.

into the end of the steering actuator rod, and secure it with the lock nut

, washers

(Power Cable Extensions, page

, and linkage arm

NOTICE

9).

NOTICE

onto the linkage pin.