- ページ 4

海上ラジオ Garmin GHS 10のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GHS 10 10 ページ。 Vhf 300 series
Garmin GHS 10 にも：取付説明書 (12 ページ), 取付説明書 (12 ページ), 取付説明書 (17 ページ)

ページを印刷する

Step 3: Connect the VHF 100/200 Series Radio to Power

The VHF 100/200 series radios have a power-cable wiring harness that connects to power and provides interface capabilities for connecting

external devices.

Notes:

•

The replacement fuse on the power cable wiring harness is a 10 A, slow-blow fuse.

•

If it is necessary to extend the power wires, use 18 AWG wire.

•

If your boat has an electrical system, you might be able to wire the radio directly to an unused holder on your current fuse block. If you

are using the fuse block, remove the in-line fuse holder supplied with the radio. You can also wire the radio directly to the battery.

To VHF 100 or

00 series radio

CAUtIoN: The VHF 100/200 series radio maximum input voltage is 15.6 Vdc. Do not exceed this voltage, because this can damage the radio and

void the warranty.

Note: During a typical installation, use only the red and black wires. The other wires are used for NMEA 0183 and other connections, and do not

have to be connected for normal operation of the radio. For information on connecting to a NMEA 0183-compatible device, see

To install the power-cable wiring harness:

1. Use a test light or voltmeter to determine the polarity of the voltage source.

2. Connect the red (+) wire on the power-cable wiring harness to the positive voltage terminal on the battery. (If you use the fuse block on

the boat, route the positive connection through the fuse, as shown on the Fuse Block diagram.)

3. Connect a ground wire (not included) from the ground connector screw to the negative voltage terminal on the battery, using 18 AWG

wire.

4. Connect the black (-) wire on the power-cable wiring harness to the negative voltage terminal on the battery.

5. Install or check the 10 A fuse (on the fuse block or in the in-line holder).

6. Connect the power-cable wiring harness red and black wires to the red and black wires on the back of the radio (connect the two red

wires together and the two black wires together).

CAUtIoN: Cover the connections with a waterproof, adhesive tape, such as rubber vulcanizing tape, to prevent water from

seeping into the radio.

10 A fuse

Boat ground

Fuse Block

Ground connector

screw

VHF 100/00 Series Radio Installation Instructions

To 10.8-15.6 Vdc

boat supply

page 5.