- ページ 9

海上ラジオ Garmin GTX 320のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Garmin GTX 320 37 ページ。 Garmin gtx 320/320a transponder installation manual
Garmin GTX 320 にも：メンテナンス・マニュアル (24 ページ), パイロット・マニュアル (4 ページ), インストレーション・マニュアル (43 ページ)

This section provides the necessary information for installing the GTX 320/320A Transponders, and where

required, optional accessories. Installation of the GTX 320/320A will differ according to equipment location and

other factors. Cabling will be fabricated by the installing agency to fit these various requirements. This section

contains interconnect diagrams, mounting dimensions, and information pertaining to installation. Each

installation shall be accomplished to meet the requirements of FAA AC 43.13-2A.

Carefully unpack the equipment and make a visual inspection of the unit for evidence of damage incurred during

shipment. If the unit is damaged, notify the carrier and file a claim. To justify a claim, save the original shipping

container and all packing materials. Do not return the unit to GARMIN until the carrier has authorized the claim.

Retain the original shipping containers for storage. If the original containers are not available, a separate

cardboard container should be prepared that is large enough to accommodate sufficient packing material to

prevent movement.

The antenna (GARMIN P/N 010-10160-00) should be well removed from any major protrusions, the

engine(s), propeller(s), and antenna masts. It should also be as far removed as practical from

landing gear doors, access doors, or other openings that could alter its radiation pattern.

The antenna should be mounted on the underside of the aircraft and in a vertical position when the

aircraft is in level flight.

Avoid mounting the antenna within three feet of the ADF sense antenna or any other

communication antenna and six feet from the DME antenna.

To prevent RF interference, the antenna must be physically mounted a minimum distance of three

feet from the GTX 320/320A.

If the antenna is being installed on a composite aircraft, ground planes must sometimes be added.

Conductive wire mesh, radials, or thin aluminum sheets embedded in the composite material provide

the proper ground plane allowing the antenna pattern (gain) to be maximized for optimum

transponder performance.

Install the antenna according to the antenna manufacturer's instructions and FAA AC 43.13-2A.

GTX 320/320A Installation Manual

190-00133-01

NOTE

Page 5

Rev L