ページを印刷するSomething not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer.
The dishwasher is fitted with a number of alarm systems which can help you to
quickly determine the cause of any problems.
The dishwasher will not start or stops during operation. All push buttons are
inoperative except for the On/Off push button. The indicator light of the programme
underway and one or more of the phase indicator lights (washing, drying, end of
programme) are flashing.
Press the On/off push button to switch off the dishwasher and carry out the
following suggested corrective actions listed below.
Important: If you call out an engineer to a fault listed below or to repair a fault
caused by incorrect use or installation a charge will be made, even if the
appliance is in guarantee.
Symptom
The machine will not
start
The machine does not
fill with water
The dishwasher will
not drain
Protection against
flooding is active
General
Fault code
"washing" phase
indicator light is
flashing
"drying" phase
indicator light is
flashing
"drying" and "washing"
phase indicator lights
are flashing
One or more phase
indicator lights are
flashing
Solution
The door has not been properly
closed.
The plug is not properly inserted in
the power socket.
There is a power failure.
Ensure the water tap is open.
Ensure the mains water supply has
not been cut off.
The inlet hose may be squashed or
bent. Reposition the hose.
The inlet hose may be blocked. Switch
off the water supply and clean the
filter.
The drain hose may be squashed or
bent. Reposition the hose.
The sink may be blocked. Clear any
blockages.
The drain hose extension is not
correct. Follow the instructions for
connecting to the waste.
There is no vent in the end of the
drain hose.
Close the water tap and contact the
Service Force Centre.
Switch off the dishwasher, switch it
back on and start the programme.
If the alarm reappears, call the
Service Force Centre.
27