オール・イン・ワン・プリンター Brother DCP 8085DNのPDF サービス更新情報をオンラインで閲覧またはダウンロードできます。Brother DCP 8085DN 15 ページ。 Laser fax/mfc
Brother DCP 8085DN にも：クイック・セットアップ・マニュアル (30 ページ), 部品リファレンスリスト (39 ページ), クイック・セットアップ・マニュアル (23 ページ), サービスマニュアル (18 ページ)

DCP8080DN, DCP8085DN, MFC8480DN, MFC8680DN, MFC8890DW

Symptoms:

1. When attempting to print from Tray1 the message "No Paper" appears on the LCD even

though paper is loaded in the tray.

2. There is a loud clicking/snapping noise when warming up or printing.

Possible Causes:

These symptoms are usually due to one or more of the following:

1. The Paper Empty (PE) Actuator may be stuck out of position.

2. A component within the tray drive assembly in the left frame of the machine may be damaged.

3. One or more gears on the left side of the tray may be damaged.

Explanation:

The root cause of these issues is the improper loading of paper into the tray, by either setting the

rear guide incorrectly or loading too much paper into the tray.

1. When the rear paper guide in the tray is set to a paper length that is longer than the paper

loaded in the tray, there is a gap between the front of the tray and the paper. The PE Actuator

will hang into this gap so that it is unable to detect the paper. With the actuator hanging in this

gap in front of the paper, the edge of the paper stack will catch on the actuator when an

attempt is made to remove the tray. If enough force is used while attempting to remove the

tray, the PE Actuator will be pulled out of position.

The paper length guide is

set to the LGL/A4

The tray extension is

set to the A4 position.

"No Paper" Message and Clicking Noise

March 22, 2010

Page 1 of 15

SERVICE

UPDATE No.

F1290

Actuato

Loading Letter size paper

results in an empty

space below the PE