- ページ 14
エアコン Fujitsu ABT24LBのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Fujitsu ABT24LB 18 ページ。 Floor console/under ceiling dual type
Fujitsu ABT24LB にも： 取扱説明書 (18 ページ)
ページを印刷する
SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE
When two or more air conditioners are installed in a room and the remote control
unit is operating an air conditioner other than the one you wish to set, change the
signal code of the remote control unit to operate only the air conditioner you wish
to set (four selections possible).
When two or more air conditioners are installed in a room, please contact your
retailer to set the individual air conditioner signal codes.
Selecting the Remote Control Unit Signal Code
Use the following steps to select the signal code of the remote control unit. (Note
that the air conditioner cannot receive a signal code if the air conditioner has not
been set for the signal code.)
1
Press the START/STOP button until only the clock is
displayed on the remote control unit display.
2
Press the MASTER CONTROL button for at least five
seconds to display the current signal code (initially set
to ).
3
Press the
tween
air conditioner signal code.
4
Press the MASTER CONTROL button again to return to
the clock display. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.
The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a
signal code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
code which operates the air conditioner.
13
buttons to change the signal code be-
. Match the code on the display to the
To operate only
one of multiple
air conditioners
) until you find the