- ページ 11

食器洗い機 AEG OKO FAVORIT 40660 iのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG OKO FAVORIT 40660 i 44 ページ。 Aeg dishwasher
AEG OKO FAVORIT 40660 i にも：ユーザー情報 (44 ページ), ユーザーマニュアル (40 ページ), ユーザーマニュアル (44 ページ), ユーザーマニュアル (48 ページ)

Adjust the water softener to the setting given in the table that corre-

sponds to the hardness of the water in the area where you live.

It is only possible to adjust the water hardness setting when a pro-

gramme is not running. If you have inadvertently started a programme

(an LED indicator is constantly illuminated), then the programme must

be cancelled by pressing the appropriate button.

1. The dishwasher must be switched off.

2. Manual setting:

Open the door on the dishwasher.

3. Remove the lower basket from the

dishwasher.

4. Turn the water hardness switch to 0

or 1.

5. Re-position the lower basket.

6. Electronic setting:

Press the water-softener and func-

tion buttons simultaneously and keep

them pressed.

7. In addition press the ON/OFF button.

8. The LED indicator for the water-softener button flashes.

9. Press the water-softener button again.

– The LED indicator for the water-softener button will be illuminated

continuously for an initial 5 seconds and then begin to flash.

– The number of flashes corresponds to the hardness setting.

– The sequence of flashes is repeated several times after a 5 second

pause.

10. Each time you press the water-softener button the hardness setting

will go up by 1.

(Exception: Hardness setting 1 follows hardness setting 5).

– If the hardness setting is changed, the LED indicator for the water-

softener button will confirm the change by remaining illuminated

continuously for 5 seconds and then flashing again.

– The number of flashes corresponds to the new hardness setting.

– The sequence of flashes is repeated several times after a 5 second

pause.

11. Once the hardness setting is correct, press the ON/OFF button.

The hardness setting is then saved.

Operating Instructions