- ページ 35

食器洗い機 AEG OKO_FAVORIT 6281 IのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG OKO_FAVORIT 6281 I 44 ページ。 Aeg dishwasher user manual

Connecting the Dishwasher

The dishwasher is fitted with safety devices that prevent the return of

wash water into the drinking water system and comply with the appli-

cable plumbing regulations.

• The dishwasher can be connected to cold and hot water supplies up

to max. 60 °C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Lowest permitted water pressure:

1 bar (=10N/cm2 =100 kPa)

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

The water inlet hose must not be kinked, crushed or entangled when it

is being connected up.

Connect the threaded hose fitting (DIN 259) on the water inlet hose to

a tap with an external thread (¾ inch). Tighten the threaded hose fit-

ting only by hand.

• In order that access to the tap in the kitchen is not limited by the use

of the dishwasher, we recommend the installation of an additional

tap, or the fitting a two way adapter to the existing tap.

• If you need a longer water inlet hose than that supplied, the follow-

ing VDE approved complete hose sets are to be used, these are availa-

ble from your dealer:

– Hose set "WRflex 100" (E No.: 911 239 034)

– Hose set "WRflex 200" (E No.: 911 239 035)

Installation and Connection Instructions

For a water pressure of less than 2 bar

please seek advice from customer service.

In the case of a water pressure greater

than 10 bar, a pressure reduction valve

must be used (available from your

dealer).