- ページ 19

ホブ AEG 35941GのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AEG 35941G 20 ページ。 Gas hob
AEG 35941G にも：操作およびインストール手順 (26 ページ), 操作および設置マニュアル (26 ページ), 操作およびインストール手順 (26 ページ), 操作およびインストール手順 (26 ページ), 操作およびインストール手順 (27 ページ)

Adaptation to different types of gas

Injectors replacement

• Remove the pan supports.

• Remove the burner's caps and crowns.

• With a socket spanner 7 unscrew and

remove the injectors (see diagram),

and replace them with the ones

required for the type of gas in use.

• Reassemble the parts, following the

same procedure backwards.

• Replace the rating label (placed near

the gas supply pipe) with the relevant

one for the new type of gas supply.

You can find this label in the package

of the injectors supplied with the appliance.

Should the feeding gas pressure be different or variable compared with the

required pressure, an appropriate pressure adjuster must be fitted on the gas

supply pipe, in compliance with the rules in force.

Adjustment of minimum level

To adjust the minimum level of the

burners, proceed as follows:

• Light the burner.

• Turn the knob on the minimum

position.

• Remove the knob.

• With a thin screwdriver, adjust the

by-pass screw (see diagram). If

changing from LPG to natural gas

unscrew about 1/4 turn the by-pass

screw, until a small regular flame is obtained

If changing from natural gas to LPG, completely tighten clockwise the screw,

until a small regular flame is obtained.

• Finally check the flame does not go out when quickly turning the knob from

the maximum position to the minimum position.

This procedure can easily be carried out, anyhow the hob has been positioned

or built in the working top.

FO 0392

by-pass screw