- ページ 14

ホブ AEG 6000 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 6000 Series 24 ページ。
AEG 6000 Series にも：ユーザーマニュアル (12 ページ), ユーザーマニュアル (24 ページ), ユーザーマニュアル (24 ページ)

ページを印刷する

www.aeg.com

5.1 Burner overview

A. Burner cap

B. Burner crown

C. Ignition candle

D. Thermocouple

5.2 Ignition of the burner

Always light the burner

before you put on the

cookware.

WARNING!

Be very careful when you use

open fire in the kitchen

environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

1. Push the control knob down and turn

it counterclockwise to the maximum

gas supply position ( ).

2. Keep the control knob pushed for

equal or less than 10 seconds. This

lets the thermocouple warm up. If

not, the gas supply is interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner

does not light, check if the

crown and its cap are in

correct positions.

WARNING!

Do not keep the control

knob pushed for more than

15 seconds. If the burner

does not light after 15

seconds, release the control

knob, turn it into off position

and try to light the burner

again after minimum 1

minute.

CAUTION!

In the absence of electricity

you can ignite the burner

without electrical device; in

this case approach the

burner with a flame, turn the

control knob counter-

clockwise to maximum gas

supply position and push it

down. Keep the control

knob pushed for equal or

less than 10 seconds to let

the thermocouple warm up.

If the burner accidentally

goes out, turn the control

knob to the off position and

try to light the burner again

after minimum 1 minute.

The spark generator can

start automatically when you

switch on the mains, after

installation or a power cut. It

is normal.

The hob is supplied with the

progressive valves. They

make the flame regulation

more precise.