- ページ 9

プリンター Brother GTX proのPDF クイック・ユーザー・マニュアルをオンラインで閲覧またはダウンロードできます。Brother GTX pro 15 ページ。 Garment printer
Brother GTX pro にも：リファレンス・マニュアル (13 ページ), ユーザーマニュアル (16 ページ), セットアップマニュアル (40 ページ)

WEEKLY MAINTENANCE: Suction Cap Cleaning

Suction Cap Cleaning

WEEKLY MAINTENANCE: Exhaust Cap & Lances

The four extrusion lances and the 2 holes [see in the blue circle] are located adjacent to the suction

caps at the Exhaust position. They need to be cleaned and free of dried ink. Always clean the first

hole at the front and go backward while cleaning the lances, carefully finishing with the last hole.

Exhaust Cleaning

WEEKLY MAINTENANCE: Wiper Cleaning

Cleaning top of wiper

If a more thorough cleaning is required, refer to removal of wiper in the instruction manual for a detailed cleaning.

The black silicone lips of the two suction caps should be

cleaned with the Cleaning Stick T dipped in Cleaning Solution.

It is necessary to remove the build-up of excess ink located on

the edges of the caps. It will prevent air leakage and maintain

optimal suction of the pumps. Be careful not to touch the foam.

Keep it flat.

Direction to clean

Cleaning under the

teeth on side of wiper

Cleaning Stick T

Four extrusion lances

Both white plastic wipers [White &

CMYK] should be cleaned on both

sides and tops with the Cleaning

Stick T dipped in Cleaning Solution.

Use the tip of the Cleaning Stick T

to clean under the teeth of the wiper

holder and remove the dried ink.

Be sure to use the Cleaning Stick T

separately for white ink and color ink.