- ページ 14

プリンター Brother HL-1000 SeriesのPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Brother HL-1000 Series 42 ページ。 Brother hl-1040: quick setup

Printing a Test Sample Page

We recommend that you print a test page. Refer to the instructions below.

NOTE

The following test page operation will be invalid after the printer has received any data

from your computer.

NOTE

If you have already sent data from your computer to the printer, you can print a self test

using the following steps.

1. Make sure the top cover is closed.

2. Hold down the switch and turn on the power switch. Keep the switch depressed until

the Drum lamp comes on.

3. Press the switch again to execute the test print.

The HL-1040/1050 printer can also print settings, fonts, and hexadecimal values of

received data. For more information, see

User's Guide.

If the printer does not print a test sample page, see

Q & A"

of the On-line User's Guide. If you are still unable to print a test sample page after

reviewing the information in the User's Guide, consult your dealer or Brother

representative for support.

This Setup guide, the User's Guide and an instructional video are available on the

CD-ROM. You can view the On-Line guides with the Adobe Acrobat reader software

included on the CD-ROM.

After printing the test sample page, you are ready to prepare your computer to work with the

printer. The software setup varies depending upon your computer and operating system. Refer

to the relevant following section:

Action 7-1: Installation from CD-ROM

Action 7-2: Prepare Windows 95/98 for the Printer from floppy disk

Action 7-3: Prepare Windows 3.1 for the Printer from floppy disk

Action 7-4: Prepare DOS for the Printer (Only for HL-1040/1050 Users) from floppy disk

Action 7-5: Prepare Macintosh for the Printer (Only for HL-1040/1050 Users)

Press the control panel switch.

The printer will start printing a test sample

page.

"Test Print Mode" in Chapter 3

"CHAPTER 6 TROUBLESHOOTING,

of the On-line