- ページ 21

プリンター Brother HL-1040のPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Brother HL-1040 42 ページ。 Brother hl-1040: quick setup
Brother HL-1040 にも：部品リファレンスリスト (16 ページ)

ページを印刷する

Using the Printer Status Monitor Program

Type C:\RPCX>STMX and press the Enter key to make the Printer Status Monitor Program

stay resident in your computer memory. If there are any changes to the printer status, it

displays a message on your computer screen.

If the printer status monitor program stays resident in your computer, you can monitor the

printer status on your computer screen immediately using the hot-key sequence (Ctrl+Alt+R).

To remove the Printer Status Monitor program from your computer memory, type

C:\RPCX>STMX/R and press the Enter key.

The RPC works in the environment where your printer is directly connected to your

computer. If you are using any printer buffer switches which do not support bi-directional

communication between the printer and computer, the program works only in the PC to

printer direction and cannot receive printer status information.

The program does not work with printers on a network.

If the RPC conflicts with some application software, exit your application software and

then run the RPC.

The RPC may work in the DOS-compatible box screen mode of Windows, however, it is

recommended that you completely exit from Windows to the DOS prompt before using the

RPC.

The Printer Status Monitor and some other Terminate-and-Stay programs cannot coexist in

the computer's memory. If they do not work properly together, use them one at a time.

You can suspend the Printer Status monitor with any of the following methods or

commands.

Type C:\RPCX>STMX/R and press the Enter key.

Hold the space bar down while executing the AUTOEXEC.BAT file at DOS startup to

prevent the status monitor being loaded as a TSR program.

-19 -