- ページ 2

Connecting the Monitor

To set up the monitor, ensure that the power is turned off to the monitor,

computer system, and other attached devices, then follow these steps:

Power off both the monitor and computer.

To adjust height of your monitor, unlock the stand lock on top of the stand.

Push the stand lock at arrows shown(figure A).

Connect one end of the monitor signal cable to the input connector on the

rear panel of the monitor.

Connect the other end to the 15-pin connector on the real panel of the

computer and tighter the screws. Be sure the signal cable aligns with the 15-

pin connector.

Connect the other end of the monitor signal cable to the rear panel of

Macintosh computer through a Macintosh adapter and then tighten screws.

Connect the plug from the AC adapter into the base of the monitor.

one end of the AC power cord to the AC adapter

properly grounded AC outlet that is easily accessible and close to the

monitor

Power on the computer, then the monitor.

If you see the NO SIGNAL message, check the signal cable and connectors.

After using the system, power OFF the monitor, then the computer.

Power Cord

Stand Lock

D-15P

AC adapter

Note :

message, check to make sure your system

is set to one of the factory preset modes

(see page A15), or is set to a resolution and

refresh rate within the specification limits of

this monitor.

Connect

and the other end to a

IBM

MACINTOSH

Adapter 15P

Signal cable

If you see the "OUT OF RANGE"