ページを印刷するConnecting to an Apple Macintosh II, Centris, and Quadra
Figure 4 shows the connection to an Apple Macintosh, using a
separately purchased adapter.
1.
Power OFF both the monitor and the PC.
2.
Connect the 15 pin VGA connector of the supplied signal cable to
the matching input on the back of the monitor. Tighten the
thumbscrews to secure the connection.
3.
Locate the appropriate MAC to VGA adapter block at your local
computer store. This adapter changes the high density 3 row 15
pin VGA connector to the correct 15 pin 2 row connection to mate
with your MAC. Attach the other end of the signal cable to the
side of the adapter block with 3 rows.
4.
Connect the attached adapter block/signal cable to the video
output on your MAC.
5.
Power ON the PC, then the monitor.
6.
If you see the NO SIGNAL DETECTED message, check the
signal cable and connectors.
7.
After using the system, power OFF the monitor, then the PC.
Power Cord
D-15P
Signal Cable
Figure 4
A7
Adapter 15P