- ページ 10
洗濯機 AEG 9000 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 9000 Series 32 ページ。
AEG 9000 Series にも： ユーザーマニュアル (48 ページ), ユーザーマニュアル (8 ページ)
ページを印刷する
10
www.aeg.com
2. Download and install App My AEG .
3. Make sure you started a Wi-fi
connection in the dryer. If not go to
the section below.
4. Start the application. Select the
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in My
AEG.
5. Follow the instructions on the App for
the appliance registration and
configuration.
A message appears on the appliance
display to confirm that the configuration
was successful.
5.2 Over-the-air update
WARNING!
During the update it is highly
recommended to not turn off
or unplug the appliance.
The App may propose an update for
downloading new features.
The update is accepted via App only.
If a programme is running, the App
notifies that the update will start at the
end of the programme.
During the update, the appliance shows
in the display.
The appliance will usable again at the
end of the update, without any
notification about successful update.
If an error occurs, the appliance shows
in the display: just press any
buttons or turn the knob to return to
normal use.
5.3 Wireless connection
configuration
Before you begin configuration download
and install My AEG application on your
smart device.
1. Push the On/Off button to switch on
the appliance.
2. Wait approximately 8 seconds.
3. Touch and hold down the Dryness
Level and Quiet buttons at the same
time for 3 seconds until a 'click'
sounds.
The symbols:
and
the display. After few seconds remains
only flashing symbol:
module is activating around 1 minute.
When ready the symbol:
Point) appears on the display. Access
Point is open around 3 minutes.
4. Configure My AEG application on
your smart device.
If the configuration is successful the
symbol:
(Access Point) disappears
and the symbol:
Each time you switch the
appliance on, the appliance
attempt to connect to the
network automatically. When
the connection is established
the symbol:
flashing.
To switch off the wireless connection ,
touch and hold down Dryness Level and
Quiet buttons at the same time for 3
seconds. The symbol:
the display.
Appliance stores last
connection configuration. To
use wireless features of the
appliance the wireless
connection must be in
mode.
To remove the wireless credentials,
touch and hold down Dryness Level and
Quiet buttons at the same time for 10
seconds. The symbol:
appears on the display.
appear on
. Wireless
(Access
stops flashing.
stops
appears on