ノートパソコン Fujitsu Lifebook A3040のPDF ソフトウェアマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Lifebook A3040 29 ページ。 Bios setup utility
Fujitsu Lifebook A3040 にも：バイオマニュアル (24 ページ)

ページを印刷する

A Series BIOS

BIOS SETUP UTILITY

The BIOS Setup Utility is a program that sets up the

operating environment for your notebook. Your BIOS

is set at the factory for normal operating conditions,

therefore there is no need to set or change the BIOS

environment to operate your notebook.

The BIOS Setup Utility configures:

Device control feature parameters, such as changing

I/O addresses and boot devices.

System Data Security feature parameters, such

as passwords.

Entering the BIOS Setup Utility

To enter the BIOS Setup Utility do the following:

1. Turn on or restart your notebook.

2. Press the [F2] key once the Fujitsu logo appears

on the screen. This will open the main menu

of the BIOS Setup Utility with the current

settings displayed.

3. Press the [RIGHT ARROW] or [LEFT ARROW] key

to scroll through the other setup menus to review or

alter the current settings.

Navigating Through The Setup Utility

The BIOS setup utility consists of seven menus: Main,

Advanced, Security, Power, Boot, Info, and Exit. This

document explains each menu in turn, including all

submenus and setup items.

The following procedures allow you to navigate the

setup utility menus:

1. To select a menu, use the cursor keys:

2. To select a field within a menu or a submenu, use the

cursor keys:

3. To select the different values for each field, press the

[Spacebar] or [+] to change to the next higher selec-

tion and [F5] or [-] to go to the next lower selection.

4. To activate a submenu press the [Enter] key.

5. To return to a menu from a submenu, press

the [Esc] key.

6. To go to the Exit menu from any other menu,

press the [Esc] key.

P O I N T

Selecting a field causes a help message about that field

to be displayed on the right-hand side of the screen.

P O I N T

Pressing the Enter key with the highlight on a selection

that is not a submenu or auto selection will cause a list

of all options for that item to be displayed. Pressing the

Enter key again will select the highlighted choice.

7. Pressing the [F9] key resets all items in the BIOS to

the default values.

8. Pressing the [F10] key saves the current configura-

tion and exits the BIOS Setup Utility. You will be

asked to verify this selection before it is executed.

9. Pressing the [F1] key gives you a general help screen.

Entering the Setup Utility After a Configuration

Change or System Failure

If there has been a change in the system configuration

that does not agree with the parameter settings stored

in your BIOS memory, or there is a failure in the system,

the system beeps and/or displays an error message after

the Power On Self Test (POST). If the failure is not

too severe, it will give you the opportunity to modify

the settings of the setup utility, as described in the

following steps:

1. When you turn on or restart the computer there is

a beep and/or the following message appears on

the screen:

Error message - please run SETUP

program Press <F1> key to continue,

<F2> to run SETUP

A S e r i e s B I O S