- ページ 11
ラベルメーカー Brother Innov-is 1000のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Brother Innov-is 1000 42 ページ。 Users manual - spanish
Brother Innov-is 1000 にも: ユーザーマニュアル (1 ページ), クイック・リファレンス・マニュアル (26 ページ), ユーザーマニュアル (1 ページ), ユーザーマニュアル (1 ページ), クイック・リファレンス・マニュアル (26 ページ), (ユーザーガイド (1 ページ)
Brother
Embellishment
Feet
19
Braiding Foot
Clear-view Foot
Baby Blanket, Pillow & Bib
created by June Mellinger
Braiding Foot
Attaches up to 3/16 inch (5 mm) wide braids, ribbons, tapes, cords, etc.
1. Loosen the screw on the presser foot and insert a braid through the guide before
attaching the presser foot on the machine.
2. Slide the plate of the guide back and forth to fit the width of the braid.
3. Tighten the screw and pull the braid behind the presser foot.
4. Attach the presser foot onto the machine.
5. Set the zigzag width slightly wider than the width of the braid.
6. Stitch braid in place.
SA141
All Brother home-use sewing machines
Clear-view Foot
Use this presser foot where visibility of seams or pattern markings are
desired. Perfect for quilting appliqué!
1. Attach the presser foot and select a stitch from satin or decorative stitches.
2. Line up the center guide mark on the presser foot over the desired seams or pattern markings.
3. Sew.
SA145
SA144
ABCDEFGHJKLMNO
IP
Cording Foot (5-hole)
Cording Foot (7-hole)
Cording Foot
Used for embellishing 1 to 3 cords or
decorative threads. Perfect for couching!
1. Slip a cord from the right of the presser foot, and place
each cord into each guide (to use single cord, use the
center guide).
2. Place cord under the presser foot, and select zigzag
stitch with maximum stitch width.
Cording Foot (5-hole)
Used for embellishing 1 to 5 cords or
decorative threads. It can be used with
brother sewing machines of 7 mm feed width.
1. Insert cords or threads into each hole on the presser foot.
2. Attach the presser foot and pull cords under the presser foot.
3. Line up the cords, and select zigzag stitch with maximum
stitch width.
Cording Foot (7-hole)
Used for embellishing 1 to 7 cords or decorative threads.
It can be used with brother sewing machines of 7 mm feed width.
1. Insert cords or threads into each hole on the presser foot.
2. Attach the presser foot and pull cords under the presser foot.
3. Line up the cords, and select zigzag stitch with maximum stitch width.
SA158
ABCDEFJKMN
Brother
Embellishment
Feet
Cording Foot
20
SA110
SA148
ABCDEFJKMN
GHILOP
SA157
ABCDEFJKMN
www.brother.com