- ページ 18

洗濯機 AEG KO-LAVAMAT 88840のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG KO-LAVAMAT 88840 48 ページ。 Aeg prosteam condenser dryer user manual

ページを印刷する

ProSteam system

LONG ANTICREASE

A 90 minute anti-crease phase is set. The display now shows the long anti-crease

icon.

If this additional option is selected, the anti-crease phase (30 min.) at the end of the ProS-

team cycle is lengthened by 60 minutes. The laundry can be removed at any time during

the anti-crease phase.

BUZZER

The appliance is supplied with the BUZZER function deactivated. The button is used to

switch the function on or off. When the function is active, the BUZZER symbol appears in

the display.

The buzzer sounds or plays a tune during:

– cycle end

– anti-crease phase and when phase starts or ends

– cycle interruption by a warning

– alarm

CHILD LOCK

The child lock can be set to prevent a programme being accidentally started or a programme

in operation being accidentally changed. The child safety device locks all buttons and the

programme knob. The child safety device can by deactivated by holding down the OPTION

and OK buttons simultaneously for 5 seconds.

– Before programme is started: appliance cannot be used

– After programme is started: programme in operation cannot be changed

The child lock

icon appears in the display to indicate that the child lock is activated. The

child lock is not deactivated once the programme comes to an end. If you want to set a

new programme, you must first deactivate the child lock.

SPIN SPEED

If the washing in the washing machine was initially drained prior to the ProSteam cycle,

the dryer can be set according to the spin speed of the initial drainage procedure. The higher

the spin speed was, the shorter the programme length for the drying cycle.

Activate the SPIN SPEED option and then number of times press OPTION button until the

desired spin speed of the initial drainage is displayed. No value is shown if no spin speed is

selected.

In certain programmes the spin speed has not effect (time controlled cycles), its selection

can be not selectable and only three dashes are visualized. Available selections: from 800

to 1800 rpm's in 100 rpm's intervals.

The maximum value depends by selected program, the minimum is always 800 rpm

For those programs where the spin speed has no effect (time controlled cycles), the selection

is not allowed and three dashes "- - -" are displayed that has the meaning of not set or

unknown.

The user interface always remembers last spin selection, and proposes it as default for all

new selected programs. If memorized spin speed is greater than maximum allowed value

it will be automatically reduced to max spin speed available for the selected program.

Setting DELAY function

With the DELAY button, you can delay the start of a ProSteam programme by be-

tween 30 minutes and a maximum of 20 hours.