- ページ 24

洗濯機 AEG KO-LAVAMAT 88840のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG KO-LAVAMAT 88840 48 ページ。 Aeg prosteam condenser dryer user manual

Drying

– Before programme is started: appliance cannot be used

– After programme is started: programme in operation cannot be changed

The child lock

child lock is not deactivated once the programme comes to an end. If you want to set a

new programme, you must first deactivate the child lock.

SPIN SPEED

If the washing in the washing machine was initially drained prior to the drying cycle, the

dryer can be set according to the spin speed of the initial drainage procedure. The higher

the spin speed was, the shorter the programme length for the drying cycle.

Activate the SPIN SPEED option and then number of times press OPTION button until the

desired spin speed of the initial drainage is displayed. No value is shown if no spin speed is

selected.

In certain programmes the spin speed has no effect (time controlled cycles), its selection is

not possible and only three dashes are visualised. Available selections: from 800 to 1800

rpm's in 100 rpm's intervals.

The maximum value depends on the selected program, the minimum is always 800 rpm

For those programs where the spin speed has no effect (time controlled cycles), the selection

is not allowed and three dashes "- - -" are displayed that has the meaning of not set or

unknown.

The user interface always stores the last spin selection, and proposes it as default for all

new selected programs. If memorised spin speed is greater than maximum allowed value

it will be automatically reduced to max spin speed available for the selected program.

Selecting TIME

To select the programme duration after setting the TIME programme. You can select a

programme duration from 10 minutes to 3 hours in 10-minute steps.

1. Turn the programme knob to the TIMED PROGRAMME. The 0:10 minutes is in the display

(corresponding to the cooling phase).

2. Press the TIME button repeatedly until the desired programme duration is shown in the

display, e.g. 0:20 for a programme of 20 minutes.

If the programme duration is not selected, the duration is automatically set to 10 mins.

See chapter ProSteam system, section Selecting DELAY START.

Press the START PAUSE button. The programme starts.

The progress bar and the name of currently performed phase, above it, show stage of the

cycle.

With wet laundry, after a few minutes the appliance will show the correct programme

duration and foreseen time of cycle end.

It is normal for the appliance to make noises during drying programme if garments with

hard parts, such as metal buttons, are put in the drum.

icon appears in the display to indicate that the child lock is activated. The