ページを印刷する
Problem
The spin phase
does not operate.
The programme
does not start.
There is water on
the floor.
You cannot open
the appliance
door.
The appliance
makes an unusual
noise.
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
Possible cause
The spin phase is off.
The filter of the drain
pump is blocked.
Balance problems with
the laundry load.
The mains plug is not
connected in the mains
socket.
Blow out fuse in the
household fuse box.
You did not press button
4
.
The delay start is set.
The Child Lock function
is activated.
Leakages from the cou-
plings of the water ho-
ses.
Leakages from the drain
pump.
The water drain hose is
damaged.
The washing programme
is in operation.
There is water in the
drum.
Incorrect level of the ap-
pliance.
You did not remove the
packaging and/or the
transit bolts.
The load is very small.
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
Possible solution
Set the spin programme.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Adjust manually the items in the
tub and start the spin phase
again.
Put in the mains plug.
Replace the fuse.
Press button
.
4
To start immediately the pro-
gramme, cancel the delay start.
Deactivate the Child Lock func-
tion.
Make sure that the couplings are
tight.
Make sure that the drain pump
filter is tight.
Make sure that the water inlet
hose has no damages.
Let the washing programme end.
Set the drain or the spin pro-
gramme.
Adjust the level of the appliance.
Refer to 'Installation'.
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
Add more laundry in the drum.
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
ENGLISH
27