- ページ 26

ラベルメーカー Brother PT-E500のPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Brother PT-E500 46 ページ。 Electronic labeling system
Brother PT-E500 にも：取扱説明書 (6 ページ)

ページを印刷する

GETTING STARTED

Alkaline/Ni-MH Battery

After making sure that the power is off, remove the rear cover

on the back of the P-touch labeling system. If the batteries

are already in the P-touch labeling system, remove them.

Make sure that the power is turned off when replacing

batteries.

Insert six new AA-size alkaline batteries (LR6), or fully

charged Ni-MH rechargeable batteries (HR6), making sure

that the positive (+) and negative (-) ends of the batteries

match the positive (+) and negative (-) marks inside the

battery compartment.

Users of alkaline batteries

Always replace all six batteries at the same time using brand

new ones.

Users of Ni-MH rechargeable batteries

Always replace all six batteries at the same time with fully

charged ones.

Visit us at http://solutions.brother.com/ for the latest

information about recommended batteries.

Attach the rear cover by inserting the three hooks at the

bottom into the slots on the P-touch labeling system, then

pushing down firmly until it snaps into place.

• Remove the batteries if you do not intend to use the P-touch labeling system for an extended

period of time.

• Dispose of the battery at an appropriate collection point, not in the general waste stream. In

addition, be sure to observe all applicable federal, state, and local regulations.

• When storing or discarding the battery, wrap it (for example with

cellophane tape), to prevent it from short-circuiting.

(Battery insulation example)

1. Cellophane tape

2. Alkaline or Ni-MH battery

Power Supply