- ページ 26
洗濯機 AEG L 87680 FLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG L 87680 FL 36 ページ。
AEG L 87680 FL にも： ユーザーマニュアル (40 ページ), ユーザーマニュアル (32 ページ), ユーザーマニュアル (36 ページ)
ページを印刷する
26 www.aeg.com
Problem
You cannot open
the appliance
door.
The appliance
makes an unusual
noise.
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
18. INSTALLATION
18.1 Fixing plate kit
(4055171146)
Available from your authorized dealer.
Possible cause
Leakages from the drain
pump.
The water drain hose is
damaged.
The washing pro-
gramme is in operation.
There is water in the
drum.
Incorrect level of the ap-
pliance.
You did not remove the
packaging and/or the
transit bolts.
The load is very small.
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
Possible solution
Make sure that the drain pump
filter is tight.
Make sure that the water inlet
hose has no damages.
Let the washing programme
end.
Set the drain or the spin pro-
gramme.
Adjust the level of the appli-
ance. Refer to 'Installation'.
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
Add more laundry in the drum.
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
If you install the appliance on a plinth,
secure the appliance in the fixing plates.
Follow the instructions supplied with the
kit.