- ページ 25

ラベルメーカー Brother PT-MTのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Brother PT-MT 45 ページ。
Brother PT-MT にも：部品リファレンスリスト (14 ページ)

3.2

Reassembly Procedure

[ 1 ]

Installing the Enter Key, Select Dial Claw, Select Dial, Dial Sheet, Lens, and Rubber

4 Key

(1) Apply a rice-sized pinch of grease (Shin-Etsu Silicone G501) to each of the two

lubrication points on the end of the body cover which the inside of the select dial will

come into contact with, as shown below.

(2) Snap the Enter key into the select dial according to the orientation keys.

(3) Set the select dial claw to the body cover.

After setting, apply a rice-sized pinch of grease (Shin-Etsu Silicone G501) to the top

of the select dial claw, as shown below.

(4) Place the body cover upside down.

(5) Set the select dial to the body cover while aligning any low section of the inner dial

face with the top of the select dial claw.

(6) While pushing up the select dial, put the dial sheet. Secure the select dial and dial

sheet with three screws.

(7) Check that the select dial rotates smoothly.

Figure 3.2-1 Reinstalling the Enter Key, Select Dial Claw, Select Dial, and Dial Sheet

III - 10