- ページ 27
洗濯機 AEG L 98499 FLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG L 98499 FL 40 ページ。 Aeg washer user manual
AEG L 98499 FL にも： ユーザーマニュアル (44 ページ)
ページを印刷する
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. Put 2 litre of water in the main wash
compartment of the detergent dis-
penser.
2. Start the programme to drain the
water.
FROST PRECAUTIONS
If the appliance is installed in an area
where the temperature can be less
than 0 °C, remove the remaining water
from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the
mains socket.
TROUBLE SHOOTER AND SERVICE
The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
the service centre.
With some problems, the acoustic
signals operate and the display
shows an alarm message.
Problem
The display tells
to check the tap:
the appliance
does not fill with
water.
Possible cause
The water tap is closed.
The water inlet hose is
damaged.
The filters in the water in-
let hose is blocked .
The connection of the
water inlet hose is not
correct.
The water pressure is too
low.
The water tap is blocked
or is furred with lime-
scale.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in
a container and let the water flow
out of the hose.
5. Empty the drain pump. Obey the
emergency drain procedure
6. When the drain pump is empty, in-
stall the inlet hose again.
WARNING!
Make sure that the temperature
is more than 0 °C before you
use the appliance again.
The manufacturer is not respon-
sible for damages that the very
low temperature can do.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Open the water tap.
Make sure that the water inlet
hose has no damages.
Clean the filters. Refer to 'Care
and cleaning'.
Make sure that the connection is
correct.
Contact your local water authori-
ty.
Clean the water tap.
ENGLISH
27