- ページ 5
ラベルメーカー Brother QL-1110NWBのPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Brother QL-1110NWB 9 ページ。
Brother QL-1110NWB にも: クイック・セットアップ・マニュアル (9 ページ), マニュアル (2 ページ)
6. LED Indications
The indicators light and flash to indicate the Label Printer's status.
Status LED
Not lit
Steady green light
Flashing green light
Steady orange light
Flashing orange light
Steady red light
Flashing red light
* Rapidly = at 0.3 second intervals.
NOTE
See the Troubleshooting section in this guide for tips on how to fix errors.
Wi-Fi LED
Wi-Fi LED
Not lit
Steady green light
Flashing green light
Bluetooth LED
Bluetooth
Not lit
Steady blue light
Flashing blue light
Condition
Power is Off
The Label Printer is in one of the following modes:
• Idle mode
• Initializing mode
• Feeding mode
• Printing mode
• Cutting mode
• Mass storage mode
• WPS setting mode
The Label Printer is doing one of the following:
• Receiving data
• Canceling the print job
One of the following is occurring:
• The DK Roll Compartment Cover is open. Close the DK Roll Compartment Cover correctly.
• Resetting mode is on.
The Cutter (
) Button was pressed while resetting.
For more information on resetting the Label Printer, see the User's Guide.
• Label Printer is in System off mode
If the orange light flashes at 0.5 second intervals continuously, the Label Printer is in Cooling mode
If the orange light flashes at 0.5 second intervals three times, the Label Printer is being
discovered by another device.
The Label Printer is in Boot mode
Contact Brother Customer Service.
If the red light flashes at one second intervals, one of the following errors has occurred:
• Roll end error
• No media error
• Wrong media error
• Feed error
• Cover open error
• Transferred data error
• Memory full error
• Access Point connection error
If the red light is off for one second, flashes twice rapidly*, and goes off again, then one of the
following errors has occurred:
• Cutter error
• Mass storage error
• USB host power supply excessive voltage error
• USB host unsupported device connection error
If the red light flashes at a rate of one second off, rapidly* on, rapidly off, rapidly on, rapidly off,
rapidly on, then a USB host hub connection error has occurred.
If the red light flashes rapidly*, there is a system error.
When you press a button other than the Power (
to the cause of the error. Contact Brother Customer Service.
Condition
Wi-Fi is off
Wi-Fi is on and connected.
If the green light is on for one second, off for two seconds, and then repeats, the Wi-Fi is on but
not connected.
Condition
Bluetooth is off
Bluetooth is on.
If the blue light flashes at 0.5 second intervals, the Label Printer is Pairing.
If the blue light flashes at 1 second intervals, the Label Printer is automatically reconnecting.
) Button, the flash pattern changes according