- ページ 12

サーバー Fujitsu Primergy RX100 S4のPDF サービス補足マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Primergy RX100 S4 43 ページ。
Fujitsu Primergy RX100 S4 にも：スタートマニュアル (8 ページ)

Safety notes

CAUTION!

This device has a specially approved power cable and must only be

connected to a grounded insulated socket.

Ensure that the power socket on the device or the grounded wall

outlet is freely accessible.

The ON/OFF button does not disconnect the device from the mains

voltage. To completely disconnect it from the mains voltage, remove

the power plug from the insulated socket.

Always connect the device and the attached peripherals to the same

power circuit. Otherwise you run the risk of losing data if, for example,

the central processing unit is still running but the peripheral device

(e.g. storage subsystem) has failed during a power outage.

Data cables to peripheral devices must be adequately shielded.

To the LAN wiring the requirements apply in accordance with the

standards EN 50173 and EN 50174-1/2. As minimum requirement

the use of a protected LAN line of category 5 for 10/100 MBps

Ethernet, and/or of category 5e for Gigabit Ethernet is considered.

The requirements of the specification ISO/IEC 11801 are to be

considered.

Route the cables in such a way that they do not form a potential

hazard and that they cannot be damaged. When connecting up a

device, refer to the relevant notes in this manual.

Never connect or disconnect data transmission lines during a storm

(lightning hazard).

In emergencies (e.g. damaged casing, controls or cables, penetration

of liquids or foreign matter), switch off the device immediately and

remove the power plug.

Proper operation of the device (in accordance with IEC 60950/

EN 60950) is only ensured if the casing is completely assembled and

the rear covers for the installation openings have been put in place

(electric shock, cooling, fire protection, interference suppression).

Service Supplement

RX100 S4