- ページ 20

サーバー Fujitsu PRIMERGY TX150 S6のPDF サービス補足マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu PRIMERGY TX150 S6 45 ページ。
Fujitsu PRIMERGY TX150 S6 にも： 使用上の注意 (8 ページ)

ページを印刷する
Fujitsu PRIMERGY TX150 S6 サービス補足マニュアル

Replacing the standard PS

Ê Push the new operating panel module into its bay as far as it is possible to
have access to the cable tie.
Ê Thread the cables through the cable tie.
Ê Push the operating panel module into its bay as far as it is possible to plug
the cables.
Ê Connect the cables (ribbon cable, USB cable and perhaps ServerView Local
Service Panel cable) to the operating panel board (see the board layout on
page
39).
Ê Push the operating panel module into the housing until it engages.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
4.3
Replacing the standard PS
Ê Open the server as described in the
I
You can replace the power supply without removing the adapter plate.
Ê Disconnect all power cables from the system board and the drives (see the
cabling plans in the Options Guide).
Figure 3: Removing the screws
Ê Remove the four screws of the standard power supply (see the circles).
20
section "Preparation" on page
Service Supplement
Replacement routines
17.
TX150 S6