- ページ 21

スキャナー Fujitsu FI-6000NSのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu FI-6000NS 35 ページ。 Fujitsu fi-6000ns: user guide
Fujitsu FI-6000NS にも：仕様 (2 ページ)

ページを印刷する

5. Select whether "Daylight Savings Time" should

be on or off.

This option is not shown for timezones where

daylight savings time is not used.

6. Press the [OK] button.

⇒

The Region/Timezone is set.

Continue with IP address/DHCP settings.

3.5 Setting the IP Address/DHCP

An IP address must be set in order to connect the

scanner to a network.

Do not use an IP address that already

ATTENTION

exists in the network.

IP address duplication will cause an

error during setup.

1. Select the [Network Settings] tab on the top

menu.

2. Select the [IP Address] tab on the left side

menu.

⇒

The IP address/DHCP screen appears.

3. Set the scanner's IP address. This may be

done automatically, by pressing the DHCP [On]

button.

The IP address may also be set manually, by

pressing the DHCP [Off] button and entering

the following numerical addresses:

• IP Address

• Subnet Mask

• Default gateway

4. Press the [OK] button.

⇒

The information entered is set.

If the IP address is the same as one

HINT

already in use, network communication

problems will occur. In this case, try the

following steps:

1. Disconnect the LAN cable and turn the

scanner off.

2. Reboot the scanner with the LAN cable

still disconnected, and enter a non-

duplicate IP address.

3. Re-connect the LAN cable to the scanner.

When DHCP is set to "On", the following

settings are assigned by the DHCP:

•

Even if DNS or WINS server is set, priority

is given to the scanner settings over the

DHCP settings.

Continue with the DNS settings.

Network Scanner fi-6000NS Getting Started

IP Address

Subnet Mask

Default Gateway

DNS Server

WINS Server