- ページ 17

スキャナー Fujitsu FI-6130のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu FI-6130 20 ページ。 Color duplex workgroup scanners
Fujitsu FI-6130 にも：パンフレット＆スペック (2 ページ), 取扱説明書 (10 ページ), はじめに (23 ページ), クリーニングとメンテナンス (47 ページ), 洗浄方法 (2 ページ)

Appendix1

■ Troubleshooting checklist

Symptom

Scanner does not turn on.

Scanning does not start.

Check this item

Have you pressed the power button on?

Are the AC cable and AC adapter

properly connected to the

scanner?

Is Windows normally started up?

Are the documents loaded correctly on the

ADF paper chute?

Is the ADF closed completely?

Is the USB cable properly connected?

Does the Function Number Display

indicates an alarm or an error?

Does the alarm state remain displayed

even after the scanner has been turned off

and back on again?

fi-6130/fi-6230 Image Scanner Getting Started

Remedy

Push the power button.

Correctly connect the AC cable and the AC adapter.

Disconnect the AC cable and the AC adapter from

the scanner, then connect them again.

If this does not restore the power supply, contact

the store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

Push the power button again after completely

starting up Windows.

Load the document correctly on ADF paper chute.

Close the ADF completely.

Correctly connect the cable. (When a USB hub is

used, check the hub's power supply.)

When the Function Number Display indicates an

alarm or an error, refer to chapter 6 "Troubleshoot-

ing" of "fi-6130/fi-6230 Operator's Guide" for

removing the alarm or the error.

Turn off and on the power button.

If this does not eliminate the alarm state, contact the

store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

AP-1