- ページ 32

スキャナー Fujitsu PA03338-B005 - FI-5750C Image ScannerのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu PA03338-B005 - FI-5750C Image Scanner 42 ページ。 Image scanner

ページを印刷する

Appendix 1 Troubleshooting

Before you ask for repair service, check the following items. If the problem persists even after implementing
remedies below, contact the dealer where your purchased the or an authorized FUJITSU service provider.
Troubleshooting checklist
Symptom
Scanner cannot be
tuned ON.
Scanning does not start.
Vertical lines appear in
the printed images.
The printed scanned
image shifts or is dis-
torted.
AP-2
Check this Item
Did you push the power switch?
Is AC cable connected correctly?
Is Windows normally started up?
Is the shipping lock unlocked?
Are the documents loaded
correctly on the ADF paper chute?
Is the ADF closed completely?
Is USB or SCSI cable connected
correctly?
Is the SCSI ID set correctly?
(When using SCSI interface)
Does the Function No. display
indicates an alarm or an error?
Does the alarm state remain
displayed even after the scanner
has been turned OFF and back ON
again?
(When using the Flatbed)
Are the glass and document
holding pad dirty?
(When using the ADF)
Is the glass inside the ADF dirty?
(When using the Flatbed)
Are the glass and document
holding pad dirty?
(When using the Flatbed)
Is the document holding pad
dirty?
(When using the ADF)
Is the ADF cover pressed down or
heavy object placed on the ADF
during scanning?
(When using the ADF)
Is something causing the scanner
to vibrate during scanning?
TABLE 1.
Remedy
Push the power switch.
Correctly connect the AC cable.
Disconnect the AC cable from the scanner,
then connect it again. If this does not restore
the power supply, contact the dealer where you
purchased the scanner or an authorized
FUJITSU scanner service provider.
Push the power switch again after completely
starting up Windows.
Unlock the shipping lock.
Load the document correctly on ADF paper chute.
Close the ADF completely.
Correctly connect the cable. (When a USB hub is
used, check the hub's power supply.)
Set the SCSI ID correctly using SCSI ID switch on
the rear of the scanner.
When the Function No. display indicates an alarm
or an error, refer to "6 TROUBLE SHOOTING" in
the "fi-5750C Operator's Guide".
Turn OFF and ON the scanner.
If this does not eliminate the alarm state, contact
the dealer where you purchased the scanner or an
authorized FUJITSU service provider.
Clean the glass and document holding pad
following the instructions in "4.3 Cleaning
Flatbed" of the "fi-5750C Operator's Guide".
Clean the glass following the instruction in "4.2
Cleaning ADF" of the "fi-5750C Operator's
Guide".
Clean the glass and document holding pad
following the instructions in "4.3 Cleaning
Flatbed" of the "fi-5750C Operator's Guide".
Install the document holding pad correctly.
Do not press down the ADF nor place heavy
objects on the ADF during scanning.
Do not allow anything to cause the scanner to
vibrate while scanning.