- ページ 6
スキャナー Fujitsu ScanSnap S1300iのPDF はじめにをオンラインで閲覧またはダウンロードできます。Fujitsu ScanSnap S1300i 10 ページ。 Color image scanner
Fujitsu ScanSnap S1300i にも： スタートマニュアル (9 ページ), 仕様 (3 ページ), はじめに (10 ページ), 安全上のご注意 (11 ページ), マニュアル (2 ページ)
ページを印刷する
3.
Connect the cables to the ScanSnap.
ATTENTION
To power on the ScanSnap, the USB
cable and either of the power cables
(power cable or USB bus power cable)
need to be connected.
When using a USB hub, make sure to
connect the ScanSnap to the USB hub
which is connected to a USB port of your
computer. Use a powered hub equipped
with an AC adapter.
If the USB port or the USB hub is version
1.1, scanning speed will slow down.
Connect the USB cable with the USB
mark facing up.
Using the Power Cable
1. Connect the power cable
connector of the ScanSnap, and plug it in the
AC outlet.
2. Connect the USB cable
connector on the ScanSnap and the USB
port on your computer.
Using the USB Bus Power Cable
1. Connect the USB bus power cable
power connector on the ScanSnap and the
USB port on your computer.
to the power
to the USB
to the
6
2. Connect the USB cable
connector on the ScanSnap and the USB
port on your computer.
4.
Open the ADF paper chute (cover) of the
ScanSnap.
ADF paper
chute
(cover)
The ScanSnap is powered on and the
[Scan] button lights in blue.
ATTENTION
The bottom part of the ScanSnap may
become hot when the ScanSnap is being
used but this does not affect ScanSnap
operation or cause any physical harm. Be
careful not to drop the ScanSnap when
carrying it.
When the ScanSnap is turned on and left
unused for 4 hours, it will turn itself off
automatically. To turn the ScanSnap
back on, perform one of the following
operations:
- Press the [Scan] button
- Close the ADF paper chute (cover) and
open it again
The time until power-off can be changed.
For details, refer to the Basic Operation
Guide.
to the USB
[Scan] button